All
Toro Aqua-Traxx Drip Tape
The premium choice for drip irrigation, Aqua-Traxx with the PBX Advantage offers a Proportionally Balanced Cross-Section (PBX) design that optimizes flow path turbulence to effectively manage water flow, deliver uniform distribution, and reduce clogging.
Available in 15 mil, 8 mil, and 6 mil this drip tape is ideal for row crops or raised beds. Its seamless construction reduces leakage at fittings. The turbulent flow path and slit outlets allow for consistent flow rates.
• Superb watering efficiency and uniformity
• Incredible durability and plugging resistance
• Ideal for above ground, mulched or buried applications
• Use with 5/8″ tape fittings
Warranty: 6 months
Pressure Range: 4-12 PSI
Filtration Requirements: Minimum 155 mesh recommended
Installation: Blue Stripe Up
Kifco B-Series Water-Reels
Operators prefer the simplicity of the Bellows Drive. Factors that make the Electric Drive the better option for your application include the following:
1- High Travel Speeds. An electric driven model will provide higher travel speeds for light applications (0.3 inches of water or less)
2- Marginal Water Pressure. If the pressure of the water is marginal, choose the electric drive over the bellows. Electric drive models will operate on as little as 26 PSI. The Bellows driven models require a minimum of 50 PSI continuously.
3- Puddle-free Application. With the Bellows drive, there is water discharge through the discharge hose. Some applications, such as watering your horse arena, prefer to not have water exiting the discharge hose, saturating where the hose is placed. For puddle free applications without any discharge of water, the electric drive is the best choice.
When these three factors are not involved, the bellows driven models are the best choice.
There are three circumstances that usually dictate the need for engine driven Water-Reels instead of turbine driven Water-Reels.
1- High Travel Speeds. An engine driven model should be used if high travel speeds are needed for light applications (0.3 inches of water or less). Engine driven travelers are capable of speeds two times that of turbine drives.
2- Slurry Application. If the Water-Reel is applying slurry or any substance that contains significant solids, an engine driven model should be used. Usage of a turbine driven model in a slurry application is limited due to the size of particles that can pass through a turbine motor.
3- Marginal Water Pressure. If the pressure of the water is marginal it may be wise to choose an engine driven machine. The turbine driven system will take approximately 6psi to 10 psi to power the turbine depending on the speed of travel. This additional pressure at the sprinkler may be critical.
When these three factors are not involved, the turbine driven models are the best choice.
Tube Inner Diameter Length: 1.1"x280'
Irrigation Width:68 - 118'
Irrigated Length: 314 - 339'
Irrigated Area Per Run (Acres): 0.5 - 0.9
Drive System: Bellows
GPM Range: 4 - 27
Inlet PSI Range: 45 - 103
Hours Per Full Run: 2.3 - 14
Sprinkler Included: SIME K1 or SIME Silver Tube Inner
Optional Solar Panel: Kifco Model E140 can be equipped with a highly efficient solar panel which eliminates the need for an electrical charge.
The E series does not require water psi to drive the unit, it is driven by the electric powered motor
Tube Inner Diameter Length: 1.4"x350'
Irrigation Width: 100 - 198'
Irrigated Length: 400 - 449'
Irrigated Area Per Run (Acres): 0.2 - 1.5
Drive System: Bellows
GPM Range: 18 - 80
Inlet PSI Range: 47 - 149
Hours Per Full Run: 3.7 - 10
Sprinkler Options: Sime K1, Sime Hidra, Neslon SR75 Big Gun Sprinkler, Komet Twinmax
Optional Solar Panel: Kifco Model E140 can be equipped with a highly efficient solar panel which eliminates the need for an electrical charge.
The E series does not require water psi to drive the unit, it is driven by the electric powered motor
Tube Inner Diameter Length: 1.9"x320'
Irrigation Width: 105 - 238'
Irrigated Length: 432 - 490'
Irrigated Area Per Run (Acres): 1.1 - 2.4
Drive System: Turbine or Engine
GPM Range: 26 - 148
Inlet PSI Range: 43 - 150 (Turbine) 33 - 140 (Engine)
Hours Per Full Run: 2.6 - 17.7 (Turbine) 4.6 - 9.3 (Engine)
Sprinkler Options: Sime Hidra, Nelson SR75 or Komet Twinmax
Tube Inner Diameter Length: 1.9"x580'
Irrigation Width: 108 - 211'
Irrigated Length: 634 - 685'
Irrigated Area Per Run (Acres): 2.3 - 3.2
Drive System: Turbine or Engine
GPM Range: 36 - 115
Inlet PSI Range: 61 - 148 (Turbine) 51 - 138 (Engine)
Hours Per Full Run: 4.6 - 27 (Turbine) 8.4 - 16.8 (Engine)
Sprinkler Options: Sime Hidra, Nelson SR75 or Komet Twinmax
Tube Inner Diameter Length: 2.1"x400'
Irrigation Width:105 - 235'
Irrigated Length:452 - 518'
Irrigated Area Per Run (Acres): 1.6 - 2.8
Drive System: Turbine or Engine
GPM Range: 40 - 138
Inlet PSI Range: 44 - 141 (Turbine) 34 - 131 (Engine)
Hours Per Full Run:3.4 - 22 (Turbine) 5.8 - 11.6 (Engine)
Sprinkler Options:Sime Hidra, Nelson SR75 or Komet Twinmax
Tube Inner Diameter Length: 1.9"x580'
Irrigation Width:136 - 186'
Irrigated Length:648 - 673'
Irrigated Area Per Run (Acres): 2.3 - 3.2
Drive System: Turbine
GPM Range: 62 - 107
Inlet PSI Range: 55 - 140
Hours Per Full Run:4.6 - 27
Sprinkler Options: Sime Hidra, Nelson SR75 or Komet Twinmax
Kifco Ag-Rain Water-Reels
Kifco Water-Reels are the premier hard hose travelers in the irrigation industry. Water-Reels are used around the world for portable irrigation, dust suppression, leaching, & de-watering. Our engine drive units are ideal for redistributing wastewater with up to 3% solids.
Increase crop yields and irrigate hard to reach areas. Water-Reels are an easy set and go system that can water acres in just a few unattended passes.
CFS Irrigation Supply carries a variety of sizes and options to fulfill all your irrigation needs.
Tube Inner Diameter Length: 2.7" x 980'
Irrigation Width:154'-203'
Irrigated Length:1057'-1082'
Irrigated Area Per Run (Acres): 3.7-5.0
Drive System: Turbine or Engine
GPM Range: 74-152
Inlet PSI Range: 71-128 (Turbine) 61-118 (Engine)
Hours Per Full Run: 3.3 - 32 (Turbine) 2.5 - 16 (Engine)
Sprinkler Included: Nelson SR100
Chassis Size: ST3
Tube Inner Diameter Length: 3.0" x 980'
Irrigation Width:172'-243'
Irrigated Length:1,066'-1,101
Irrigated Area Per Run (Acres): 4.2-6.2
Drive System: Turbine or Engine
GPM Range: 100-275
Inlet PSI Range: 71-144 (Turbine) 61-134 (Engine)
Hours Per Full Run: 3.3 - 32 (Turbine) 2.4 - 16 (Engine)
Chassis Size: ST4
Tube Inner Diameter Length: 3.0" x 1200'
Irrigation Width:186'-232'
Irrigated Length:1293'-1316'
Irrigated Area Per Run (Acres): 5.5-7
Drive System: Turbine or Engine
GPM Range: 125-240
Inlet PSI Range: 81 - 150 (Turbine) 71 - 140 (Engine)
Hours Per Full Run: 4.0 - 40 (Turbine) 3.0 - 20 (Engine)
Chassis Size: ST5
Kifco Ag-Rain Water-Reels
Kifco Water-Reels are the premier hard hose travelers in the irrigation industry. Water-Reels are used around the world for portable irrigation, dust suppression, leaching, & de-watering. Our engine drive units are ideal for redistributing wastewater with up to 3% solids.
Increase crop yields and irrigate hard to reach areas. Water-Reels are an easy set and go system that can water acres in just a few unattended passes.
CFS Irrigation Supply carries a variety of sizes and options to fulfill all your irrigation needs.
Tube Inner Diameter Length: 3.3"x1120'
Irrigation Width:197'-248'
Irrigated Length:1219'-1244'
Irrigated Area Per Run (Acres): 5.6-7.3
Drive System: Turbine or Engine
GPM Range: 165-330
Inlet PSI Range: 81-144
Hours Per Full Run: 3.7-37
Chassis Size: ST5
Tube Inner Diameter Length: 3.7" x 1220'
Irrigation Width:210'-285'
Irrigated Length: 1325'-1362'
Irrigated Area Per Run (Acres): 6.4-8.9
Drive System: Turbine or Engine
GPM Range: 205-415
Inlet PSI Range: 81-144
Hours Per Full Run: 4.1-41 (Turbine) 3.1-20.3 (Engine)
Chassis Size: ST6
Tube Inner Diameter Length: 4.0"x1320'
Irrigation Width:228'-298'
Irrigated Length: 1434'-1469'
Irrigated Area Per Run (Acres): 7.5-10
Drive System: Turbine or Engine
GPM Range: 205-415
Inlet PSI Range: 78-150 (Turbine) 68-140 (Engine)
Hours Per Full Run: 4.4-44 (Turbine) 3.3-22 (Engine)
Chassis Size: ST7
T-Tape Drip Tape
One of the most recognized and trusted drip tape brands in the world, T-Tape Drip Tape is used in a variety of crops around the world to help reduce water consumption, increase crop quality, and increase crop yields. T-Tape Drip Tape can be installed on the ground, under plastic, or even subsurface. T-Tape’s industry-leading material strength, design, and quality production standards ensure that it’s the drip tape that you can count on year after year.
A great thing is when you use T-Tape, closer emitter spacing intervals do not need to come at an extra cost. Because Rivulis T-Tape has emitters manufactured into the tape itself, as opposed to inserted molded emitters, there is no cost difference per meter between 10 emitters per meter (10 cm spacing) and two emitters per meter (50 cm spacing).
Ro-Drip Drip Tape
Only Ro-Drip has an expanding flow-path that enlarges when you increase water pressure. This unique feature helps expel foreign particles that would have permanently blocked other drip tapes. If you clog your Ro-Drip labyrinth, you can increase your system pressure which results in the expansion of the labyrinth flow channel, helping expel debris and normal operation to resume.
• Unique expanding vortex flow path labyrinth helps expel debris
• Available in a wide variety of emitter spacings
• Manufactured to the highest level of quality
Rivulis Drip Tape
Drip Tape is an economical solution for annual row crops, field crops, and greenhouses. Engineered with an efficient turbulent flow path, Drip Tape’s channel design minimizes clogging. Because Drip Tape is a flat integral drip tape, it is a good choice for manual or mechanized layout and retrieval. Drip Tape is available in a wide range of diameters and wall thicknesses.